Renesas SmartBond Regulator 바인딩

:orphan:

.. raw:: html

    <!--
    FIXME: do not limit page width until content uses another representation
    format other than tables
    -->
    <style>.wy-nav-content { max-width: none; !important }</style>

.. dtcompatible:: renesas,smartbond-regulator
.. _dtbinding_renesas_da1469x_regulator:

renesas,smartbond-regulator
###########################

Vendor: :ref:`Renesas Electronics Corporation <dt_vendor_renesas>`

Description
***********



.. code-block:: none

   Renesas Smartbond(tm) LDO and DCDC regulators

Properties
**********

Top level properties
====================

No top-level properties.

Child node properties
=====================

.. list-table::
   :widths: 1 1 4
   :header-rows: 1

   * - Name
     - Type
     - Details

   * - ``regulator-init-microvolt``
     - ``int``
     - .. code-block:: none

          Voltage set during initialisation


   * - ``regulator-max-microamp``
     - ``int``
     - .. code-block:: none

          largest current consumers may set


   * - ``regulator-always-on``
     - ``boolean``
     - .. code-block:: none

          boolean, regulator should never be disabled


   * - ``regulator-boot-on``
     - ``boolean``
     - .. code-block:: none

          bootloader/firmware enabled regulator.
          It's expected that this regulator was left on by the bootloader.
          If the bootloader didn't leave it on then OS should turn it on
          at boot but shouldn't prevent it from being turned off later.
          This property is intended to only be used for regulators where
          software cannot read the state of the regulator.



   * - ``regulator-initial-mode``
     - ``int``
     - .. code-block:: none

          Initial operating mode. The set of possible operating modes depends on the
          capabilities of every hardware so each device binding documentation
          explains which values the regulator supports.



   * - ``renesas,regulator-v30-ref-bandgap``
     - ``boolean``
     - .. code-block:: none

          Selects reference source for V30 LDO to Bandgap output.



   * - ``renesas,regulator-v30-clamp``
     - ``boolean``
     - .. code-block:: none

          Enables clamp that can supply V30 from VBAT.



   * - ``renesas,regulator-v30-vbus``
     - ``boolean``
     - .. code-block:: none

          Allow V30 to be powered from VBUS.



   * - ``renesas,regulator-v30-vbat``
     - ``boolean``
     - .. code-block:: none

          Allow V30 to be powered from VBAT.



   * - ``renesas,regulator-dcdc-vbat-high``
     - ``boolean``
     - .. code-block:: none

          Enable DCDC in high battery voltage mode.



   * - ``renesas,regulator-dcdc-vbat-low``
     - ``boolean``
     - .. code-block:: none

          Enable DCDC in low battery voltage mode.



   * - ``renesas,regulator-sleep-ldo``
     - ``boolean``
     - .. code-block:: none

          Enable LDO in sleep mode.